U Channel Steel Studs - China

Introduction about light steel stud:

Ceiling channel and drywall channel, made of high-quality Snowflakes Steel, adopting laminose strut channel by Cold-formed Technology, is a kind of metal framework made after several continuous rolling.

Ceiling keel and wall channel has light-weight, high-intensity, good-antisepsis and other advantages.

They mainly match to paperbacked plasterboard and other goods, also the other plates such as GRC, FT and so on.

Size (W*H):

Covering Channel DC60 60*27*0.60mm Thickness0.25-2mm, Length and other sizes can Be Provided By Customers' Requests.

DC50 50*19*0.50mm

Supporting Channel DU60 60*27*1.2mm

DU50 50*15*1.2mm

DU38 38*12*1.0mm

DU28 28*27*1.0mm

Track/Horizontal Channel QU/UW 50/75/100* 35/40/50*0.45mm

Stud /Vertical Channel QC/CW 50/75/100* 35/40/50*0.45mm

Omega Furring channel Ω 51.5*26*10mm

35*22*12/13mm

35*33*11mm

48*22*11mm

Advantages:

(1)Design according to customers’ requirements

(2)Manufacture under complete quality control system---ISO9001

(3)Installation with instruction of experienced engineers

(4)Easy to assemble and dismantle

(5)Eco-friendly material: can be used for several times and can be recycled

(6)Shorter construction period, longer using time

(7)High strength and stiffness, high weight bearing.

How to Install

Hanging drywall

1 - Finish all the electrical, plumbing and insulation work that is necessary in your walls before you begin to install any drywall.

2 - Mark the location of the wall studs on both the floor and ceiling, so you will be able to find them when you begin installing the sheet rock.

3 - Lay a piece of scrap on the floor to raise the drywall off the floor (about 1/2 inch).

4 - Starting in a corner, place the drywall onto the scrap and butt it into the corner.

Ensure the other end of the sheet falls onto the center of a wall stud.

(Sheets can be installed either vertically or horizontally.

Most pros like to install it horizontally, since this means fewer joints to fill and the main seam is about four feet off the floor - a comfortable height to work at.

)

5 - Use drywall nails or your drywall gun and drywall screws to fasten the sheet in a couple of places to hold it.

Now go back, and starting in the corner, push the drywall sheet tightly against the wall studs and fasten the sheet to all the studs it is covering.

Place screws every 6 to 8 inches.

6 - Continue around the perimeter of the room, butting sheets against each other, ensuring the ends are centered on wall studs, until the lower section is finished.

7 - Measure from the top of the bottom sheet to where the top of the wall will be (this will be the height of the top piece of drywall).

If the distance is less than 4 inches, cut the drywall sheet to the proper height and install it with the cut edge at the top.

8 - Continue installing the top row all around the room.

Company Contact:

• Posted By: Suzhou Century Sunshine CO.,LTD

• Phone: 0086051265164362

• Address: Room 623,Xinguo Road, Suzhou , China

• Email:

• Website: http://www.sunshineindustry.com

• Business Description: involved in international trade import export of goods, products, and services