How To Use C44 Roof Desk Forming Machine - China

How to use C44 roof desk forming machineC

C44 shingle molding machine is the majority of users a

molding equipment, but its time to use the correct method of

operation:

1 - C44 shingle molding machine operation, to check whether

the connection is solid throughout, installing bolts, nuts

are tightened, so the chassis lubrication should add enough

oil to power-up test machine, the first empty running

carefully observed, with or without vibration , noise, oil

window is to oil, the components are coordinated motion,

everything works before installing the mold.

2 Install C44 shingle molding machine mold, you must cut

off the power manually moving belt or gear motor, so that

the table indexing, and to rise to the highest point of

sliding seat, preferably with an object supported on the

bench and between the bottom slide to slip seat naturally

fall, causing the accident.

3 - C44 shingle molding machine equipment the first row and

the last row to find a good center, then tighten lock nut on

both sides, in the middle of the center wheel front and rear

lay a straight line, the upper and lower shaft after

adjusting the gap , you can adjust the machine along a

straight line.

4 first arc C44 glazed roof desk forming machine tile press

machine equipment before and after the two corners line up

the shaft from the large end of the height of the frame in

the end the amount of the same, and then routed to the last

row from the first, to find a line drawing straight, check,

whether the lower shaft in a straight line, the lower shaft

left and right sides tune into levels.

Tile press platen

deviation debugging methods, such as to the right to run,

pad left corner, or off the right side of the bottom level,

the first of several shaft axis deviation Ladi few flat

bottom, with the bottom of the upper shaft axis whereabouts.

Company Contact:

• Posted By: Hebei XinNuo Roll Forming Machine Co., Ltd

• Phone: 863178312992

• Address: 104 National Road, Botou, cangzhou , China

• Email:

• Business Description: Botou Xinnuo molding machine limited company is a supplier of roof plate
  
  roll forming achine, sandwich plate roll forming machine, floor plate roll
  
  forming machine, bending machine, shearing machine, cutting
  
  machine, double roll forming machine, C type steel, Z steel, light steel
  
  keel machine and so on, is a large scale technology quality
  
  manufacturers.
  
  Roll forming machine, floor deck roll forming machine, double roll forming machine